Interesting facts about the practical courses of the teaching unit Fundamentals of Electrical Engineering

At the end of each of the modules General Electrical Engineering 1, 2 and 3 (AET1, AET2 and AET3), a course achievement in the form of an internship must be completed. The GET experiments belonging to the practical courses are organized and carried out by the GET teaching group.

Enrollment

 

Electronically, manually or personally. Please observe the instructions in GET-soft in this regard.

Documents

 

The internship regulations, the experiment instructions, the cover sheet for the internship protocol and experiment-specific templates can be found at GETsoft.

Please note that the required certificate card can only be obtained after attending an introductory event for the AET internship (date: Open Timetable ).

The test card, the experiment instructions and the complete, handwritten work on the preparatory tasks must be brought to the experiment date in paper form. Without these, participation in the practical course is not possible.

Entrance test

 

The knowledge acquired through the preparatory tasks of the respective GET internship serves as a basis for the entrance test held at the beginning of the corresponding internship. The execution of the internship is only possible with a passed test.

Acceptance/output of GET protocols

will take place in the secretary's office of the Fundamentals of Electrical Engineering teaching group (room H1524) on the following dates:

  • Tuesdays
    2:30 pm - 3:00 pm
  • Wednesdays
    10:30 am - 11:00 am
  • Thursdays
    10:30 am - 11:00 am
 

No GET protocols will be accepted or issued during the semester break. In urgent cases, contact get@tu-ilmenau.de.